![]() ![]() ![]() Press the Reset button with the cable disconnected If the VCM II update failed by USB cable, please choose the second method to try! Run IDS, when the VCM II icon appears in the bottom right corner, it indicates VCM update has been completed, can use normally. ![]() When the following figure appears, it indicates that the recovery mode has been enteredĬlick “Recover” button to switch to VCM II Update interfaceĬlick on “Start Update” to update firmware, it will prompt belowĪfter the update process is completed, the following prompt interface will appear, and Ford VCM II scanner will restart, when the sound “dee” is heard, it indicates restarting process is completed. Run “Bosch\VCI Software (Ford-VCM-II)\VCI Manager (Ford-VCM-II) Is there something wrong with your Ford VCM II when you use? The device cannot be identified by PC? To take out the SD card also cannot work? Here share the solution by updating the VCM II scanner.Ĭonnect the USB cable to VCM II device, press and hold the reset button belowĬonnect the USB cable to PC which has installed IDS V86, until hear the sound “dee” then release the Reset button ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |